This is another breadboard compatible header board, that I am working on. This one is for all 28-pin AVR devices, ATmega48, ATmega88, ATmega168 and the latest ATmega328. Component count is low and there is no voltage regulator on board. That makes it easy to power it from various sources.
As a bonus, this board is a hybrid of through hole and SMT components. It has two SMD LEDs under the hood. Great to learn how to solder surface mounted devices.
It has also an FTDI-connector and runs with a 16 MHz resonator, which makes it Arduino compatible. The jumper is used to select between different power sources.
Yikes, SMD soldering. This is my first attempt at hand soldering 1206 SMT components. 1206 is only 3.2 mm Ã— 1.6 mm! But these are about the largest SMT components available. Most commonly used are way smaller, 0805, 0603 or 0402. My soldering still looks ugly, but with a bit of practice I think I can do much better.
The space on the board is a bit limitted, so there is no room to mark all pins. That’s why I have a little cheat sheet around, while wiring things up.